ASTM A888-21a
- standard by ASTM International, 09/01/2021
- Standard Specification for Hubless Cast Iron Soil Pipe and Fittings for Sanitary and Storm Drain, Waste, and Vent Piping Applications
- Category: ASTM
$85.00
$43.00
Full Description
1.1''This specification covers hubless cast iron soil pipe and fittings for use in gravity flow applications. It establishes standards covering material, manufacture, mechanical and chemical properties, dimensions, coating, test methods, inspection, certification, and product marking for hubless cast iron soil pipe and fittings. These pipe and fittings are intended for non-pressure applications, as the selection of the proper size for sanitary drain, waste, vent, and storm drain systems allows free air space for gravity drainage.
1.2''The EDP/ASA numbers indicated in this section represent a Uniform Industry Code adopted by the American Supply Association (ASA). A group designation prefix, 022, is assigned to hubless products, followed by the four-digit identification assigned to individual items and a check digit. This system has been instituted to facilitate EDP control through distribution channels, and is to be used universally in ordering and specifying product items. Those items with no EDP numbers are either new, special, or transitory and will be assigned numbers on subsequent prints of this specification.
1.3''This specification covers pipe and fittings of the following patterns and applies to any other patterns that conform with the dimensions found in Tables 1 and 2 and all other applicable requirements given in this specification.2
1.3.1''Lengths:
'' | Figures |
EDP/ASA Identification Numbers | Fig. 1 |
10 ft (3.0 m) in sizes and 5 ft. (1.5 m) | Fig. 1, Fig. 2 |
Method of Specifying Fittings | Fig. 3 |
1.3.2''Fittings:''
Quarter Bend | Fig. 5 |
Quarter Bend, Reducing | Fig. 6 |
Quarter Bend, with Side Opening | Fig. 7 |
Quarter Bend, with Heel Opening | Fig. 8 |
Quarter Bend, Tapped | Fig. 9 |
Quarter Bend, Double | Fig. 10 |
Quarter Bend, Long | Fig. 11 |
Short Sweep | Fig. 12 |
Long Sweep | Fig. 13 |
Long Sweep, Reducing | Fig. 14 |
Fifth Bend | Fig. 15 |
Sixth Bend | Fig. 16 |
Eighth Bend | Fig. 17 |
Eighth Bend, Long | Fig. 18 |
Document History ASTM A888-21aASTM A888-18aASTM A888-17aASTM A888-17ASTM A888-15ASTM A888-13ASTM A888-11ASTM A888-09ASTM A888-08aASTM A888-08ASTM A888-07ASTM A888-05ASTM A888-04aASTM A888-04ASTM A888-98e1ASTM B103/B103M-98e2Standard Specification for Phosphor Bronze Plate, Sheet, Strip, and Rolled Bar.. $30.00 $60.00 ASTM D3623-78a(1998)Standard Method for Testing Antifouling Panels in Shallow Submergence.. $29.00 $58.00 ASTM D5377-93(1998)Standard Classification for Rubber Compounding Materials-Ground Coal.. $27.00 $54.00 |