ASTM C1341-13(2023)
- standard by ASTM International, 05/01/2023
- Standard Test Method for Flexural Properties of Continuous Fiber-Reinforced Advanced Ceramic Composites
- Category: ASTM
$82.00
$41.00
Full Description
1.1 This test method covers the determination of flexural properties of continuous fiber-reinforced ceramic composites in the form of rectangular bars formed directly or cut from sheets, plates, or molded shapes. Three test geometries are described as follows:
1.1.1 Test Geometry I-A three-point loading system utilizing center point force application on a simply supported beam.
1.1.2 Test Geometry IIA-A four-point loading system utilizing two force application points equally spaced from their adjacent support points, with a distance between force application points of one-half of the support span.
1.1.3 Test Geometry IIB-A four-point loading system utilizing two force application points equally spaced from their adjacent support points, with a distance between force application points of one-third of the support span.
1.2 This test method applies primarily to all advanced ceramic matrix composites with continuous fiber reinforcement: unidirectional (1D), bidirectional (2D), tridirectional (3D), and other continuous fiber architectures. In addition, this test method may also be used with glass (amorphous) matrix composites with continuous fiber reinforcement. However, flexural strength cannot be determined for those materials that do not break or fail by tension or compression in the outer fibers. This test method does not directly address discontinuous fiber-reinforced, whisker-reinforced, or particulate-reinforced ceramics. Those types of ceramic matrix composites are better tested in flexure using Test Methods C1161 and C1211.
1.3 Tests can be performed at ambient temperatures or at elevated temperatures. At elevated temperatures, a suitable furnace is necessary for heating and holding the test specimens at the desired testing temperatures.
1.4 This test method includes the following:
Section
Scope 1
Referenced Documents 2
Terminology 3
Summary of Test Method 4
Significance and Use 5
Interferences 6
Apparatus 7
Precautionary Statement 8
Test Specimens 9
Procedures 10
Calculation of Results 11
Report 12
Precision and Bias 13
Keywords 14
References
CFCC Surface Condition and Finishing
Document History
ASTM C1341-13(2023)
ASTM C1341-13(2018)
ASTM C1341-13
ASTM D5614-94(2014)
Standard Test Method for Open Channel Flow Measurement of Water with Broad-Crested Weirs (Withdrawn..
$34.00 $68.00
ASTM D3858-95(2014)
Standard Test Method for Open-Channel Flow Measurement of Water by Velocity-Area Method (Withdrawn ..
$34.00 $68.00
ASTM E666-14
Standard Practice for Calculating Absorbed Dose From Gamma or X Radiation..
$31.00 $62.00