• ASTM D333-01(2013)

ASTM D333-01(2013)

  • standard by ASTM International, 06/01/2013
  • Standard Guide for Clear and Pigmented Lacquers
  • Category: ASTM

$62.00 $31.00

Full Description

1.1 These test methods cover procedures for testing lacquers and lacquer coatings. The test methods included are listed in .

Note 1-In accordance with Terminology , a lacquer is defined as a coating composition that is based on synthetic thermoplastic filmforming material dissolved in organic solvent(s) and that dries primarily by solvent evaporation. Typical lacquers include those based on nitrocellulose, other cellulose derivatives, vinyl resins, acrylic resins, etc.
Note 2-Lacquers may be applied under such diverse conditions, to so many different surfaces, and their dried films may be subjected to so many kinds of wear and exposure that it is not possible to assure desired performance from a single selection of test methods and numerical results therefrom. Those skilled in lacquer technology may find partial assurance of obtaining desired qualities in various types of lacquers through careful selection of the methods covered herein and intelligent interpretation of results therefrom.
Note 3-It is intended ultimately to remove all experimental procedures from Test Methods D333 and to establish them as a guide to the selection of test methods for lacquer and perhaps to interpretation of results therefrom. Temporarily there remain in Test Methods D333 a few tests that are too short or otherwise presently unsuitable for establishment under separate ASTM designations.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Product Details

Published:
06/01/2013
Number of Pages:
6
File Size:
1 file , 130 KB
Note:
This product is unavailable in Russia, Ukraine, Belarus

Document History

ASTM D333-01(2013)

ASTM D333-01(2007)

ASTM D333-01

ASTM D333-96

ASTM C1341-13

ASTM C1341-13

Standard Test Method for Flexural Properties of Continuous Fiber-Reinforced Advanced Ceramic Comp..

$43.00 $86.00

ASTM D3328-06(2013)

ASTM D3328-06(2013)

Standard Test Methods for Comparison of Waterborne Petroleum Oils by Gas Chromatography..

$30.00 $60.00

ASTM F2962-13

ASTM F2962-13

Standard Practice for Conformity Assessment of Protective Clothing Worn by Operators Applying Pesti..

$30.00 $60.00

ASTM D3695-95(2013)

ASTM D3695-95(2013)

Standard Test Method for Volatile Alcohols in Water by Direct Aqueous-Injection Gas Chromatography..

$32.00 $64.00