ASTM D6637/D6637M-15

standard by ASTM International, 07/15/2015
Standard Test Method for Determining Tensile Properties of Geogrids by the Single or Multi-Rib Tensile Method
Category: ASTM

~~$48.00~~ $24.00

Description

Full Description

1.1 This test method covers the determination of the tensile strength properties of geogrids by subjecting strips of varying width to tensile loading.

1.2 Three alternative procedures are provided to determine the tensile strength, as follows:

1.2.1 Method A-Testing a single geogrid rib in tension (N or lbf).

1.2.2 Method B-Testing multiple geogrid ribs in tension (kN/m or lbf/ft).

1.2.3 Method C-Testing multiple layers of multiple geogrid ribs in tension (kN/m or lbf/ft).

1.3 This test method is intended for quality control and conformance testing of geogrids.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.